Новости од индустријата

Преглед на коаксијален кабел

2021-03-03

Преглед на коаксијален кабел

 

1. Основна лентакоаксијален кабел

 

The коаксијален кабел uses hard copper wire as the core and a layer of insulating material. This layer of insulating material is surrounded by a densely woven mesh conductor, and the net is covered with a layer of protective material. There are two widely used коаксијален кабелs. One is a 50-ohm cспособен, which is used for digital transmission, and is also called baseband коаксијален кабел because it is mostly used for baseband transmission; the other is a 75-ohm cспособен, which is used for analog transmission, which is the broadband коаксијален кабел to be discussed in the next section. This difference is caused by historical reasons, not technical reasons or manufacturers.

 

This structure of коаксијален кабел makes it have high bandwidth and excellent noise suppression characteristics. The bandwidth of a коаксијален кабел depends on the cспособен length. A 1km cспособен can reach a data transmission rate of 1Gb/s~2Gb/s. Longer cспособенs can also be used, but the transmission rate should be reduced or intermediate amplifiers should be used. Currently, коаксијален кабелs are largely replaced by optical fibers, but they are still widely used in cспособен television and some local area networks.

 

2. Широкопојасен интернетCоаксијаленCспособен

 

A коаксијален кабел system that uses a limited TV cспособен for analog signal transmission is called a broadband коаксијален кабел. The term "broadband" comes from the telephone industry and refers to a frequency band wider than 4kHz. However, in computer networks, "broadband cспособен" refers to any cспособен network that uses analog signals for transmission.

 

Because the broadband network uses standard cспособен television technology, the usспособен frequency band is up to 300MHz (often to 450MHz); due to the use of analog signals, an electronic device needs to be placed at the interface to convert the bit stream entering the network into an analog signal, and Convert the signal output from the network into a bit stream.

 

Broadband systems are divided into multiple channels, and TV broadcasting usually occupies 6MHz channels. Each channel can be used for analog TV, CD quality sound (1.4Mb/s) or 3Mb/s digital bit stream. TV and data can be mixed on a single cспособен.

 

A major difference between a broadband system and a baseband system is that because the broadband system covers a wide area, it requires an analog amplifier to periodically strengthen the signal. These amplifiers can only transmit signals in one direction. Therefore, if there are amplifiers between computers, packet packets cannot be transmitted backwards between computers. To solve this problem, two types of broadband systems have been developed: dual-cспособен systems and single-cспособен systems.

 

1) Dual cспособен system

 

A dual cспособен system has two identical cспособенs laid side by side. In order to transmit data, the computer transmits the data through the cспособен 1 to a device at several roots of the cспособен, that is, the head-end, and then the head-end transmits the signal down the cспособен through the cспособен 2. All computers send via cспособен 1 and receive via cспособен 2.

2) Single cспособен system

 

Another solution is to allocate different frequency bands for internal and external communications on each cспособен. The low frequency band is used for communication from the computer to the top device, and the signal received by the top device is moved to the high frequency band and broadcast to the computer. In the subsplit system, the 5MHz~30MHz frequency band is used for inward communication, and the 40MHz~300MHz frequency band is used for outward communication. In the midsplit system, the inward frequency band is 5MHz~116MHz, and the outward frequency band is 168MHz~300MHz. This choice is caused by historical reasons.

 

3) Постојат многу начини да се користат широкопојасни системи.

A dedicated permanent channel can be allocated between a pair of computers; other computers can apply to establish a temporary channel through the control channel, and then switch to the applied channel frequency; and all computers can share one or a group of channels. Technically speaking, broadband cспособенs are worse than baseband (single channel) cспособенs in sending digital data, but its advantage is that it has been widely installed.